2014 MERCURY 20 HP OUTBOARD INSTALL THE DRAIN

2000 mercury 40 HP outboard motor. Fits Mercury 8 hp FourStroke outboards (BEL OPO86824-OP325499) Fits Mercury 9.9 hp FourStroke outboards (USA OG760300-OT979999) Fits Mercury 15 hp FourStroke outboards (USA OG590000 and newer) Fits Mercury 20/25/30 EFI FourStroke. Your Savings: 3.46 (29) Replaceable screw-on type canister filters.

Shaft Length: 20 (Long Shaft) This outboard is currently on order from the manufacturer. Please contact for any questions.Mercury Marine 15/20 hp 4-Stroke Oil Change KitMercury 20 HP ELH EFI Outboard Motor. The motor is 165 lbs and is a long shaft. Runs well, fuel tank comes with it.

Database contains 1 Mercury.The Mercury Pro XS outboard line has lightning-fast acceleration and quick speeds. Clean Used 2000 Mercury 200 HP EFI V6 2 Stroke 20 Outboard Motor. Mercury 25HP 4-stroke outboard.

Provides protection against rust and corrosion in wet environments and during off-season storageUltimate Wear ProtectionВ - Using new, high-tech additive technology, Mercury has 33% greater camshaft wear protection compared to other marine dealers.Each kit contains all the items needed to change oil in select Mercury 4-Stroke Outboards: Industry Leading StrengthВ - Mercury provides the longest lasting, strongest protection.Flagship Corrosion ResistanceВ - New advanced corrosion inhibitors outperform competition and all industry standards. 15 HP 20 HP 25 HP 30 HP 40 HP 50 HP 60 HP 75 HP 90 HP. The Verado line carries motors that feature low noise and vibration, lower fuel consumption, and supercharged four-stroke power.2014 Mercury 40ELPT Jet Four Stroke Outboard Motor 4,260.00 Top Outboards. This line has a range of 115-250 hp.

2014 Mercury 20 Hp Outboard Install The Drain

Disengage the tilt lock and lower the outboard. After the initial oil has been drained, temporarily reinstall the drain plug. Note: Do Not use a crankcase oil pump when changing oil or damage may occur. Remove drain plug with a 5/8' or 16mm wrenchand drain engine oil into an appropriate container. Position outboard so the drain hole is facing downward. Lock the outboard in the full tilt-up position

Positon the outboard in a level operating position. Place new seal on the drain plug and lubricate with oil. Return the outboard to the full tilt position and drain the remaining oil.

Screw new filter on until gasket contacts base, then tighten 2/3 turn. Apply film of clean oil to the filter gasket. Clean the mounting base. Unscrew old filter by turning the filter counter-clockwise. Place a rag or towel below the oil filter to absorb any spilled oil.